Trouble Shootings
- ICE Error No.F1F: No external output resources of ETM available.
- ICE Error No.F11: Modify after deleting all ETM event and break.
- ICE Error No.ff6 ETM probe is not connected properly.
- ICE Error No.F1B: No sequencer resources of ETM available.
- ICE Error No.f1c: No counter resources of ETM available.
- ICE Error No.f6d: ETM Trace Mode filter not selected.
- ICE Error No.f0a: ETM type setup error
- ICE Error No.F36: ETB function is not available.
- ICE Error No.fcb: External signal event cannot be set up while using ETB function.
- ICE Error No.fd3: DTRRX Overrun error, ICE Error No.fd4: DTRTX Underrun error
- ICE Error No.FF7: DBGRQ signal is abnormal.
- ICE Error No.F3A: CP15 access error (Undefined exception occurred.)
- ICE Error No.F42: CP15 polling time-out occurred.
- ICE Error No.f4a: CoreSight component is not found.
- ICE Error No.F47: CoreSight Rom table is not found.
- ICE Error No.F4D: Time-out waiting for execution of CoreSight ACK.
- ICE Error No.f5c: CoreSight ACK FAULT
- ICE Error No.fa4: You cannot set other than CODE area (0x0-0x1FFFFFFF).
- Error No.995: The debugger executing the cmdlnk command cannot be specified as the command link destination debugger.
- Error No.997: "cmdlnk" cannot be described in the cmdlnk command.
- ICE Error No.F10: You cannot set up ETM Resources Information when Auto Config is selected.
- ICE Error No.f4b: Failed to start AP debug.
- ICE Error No.f41: Specify address on 4-byte boundary. (ARM Area)
- ICE Error No.f7f: For APB of APSel has not been set.
- ICE Error No.f64: Cancel all software breaks before you change instruction code
- [ Error ] The process is canceled.
- ICE Error No.F2B: Imprecise data abort
- ICE Error No.F1E: You have set up events for external output exceeding the limit.
- ICE Error No.FD7: MMU-Fault Illegal address conversion table (Page).
- ICE Error No.FDC: MMU-Fault External abort is detected during a primary address conversion.