Product Components / Specification
- Is there any rule for turning on the power?
- What should I do with pins if there is no DBGRQ pin and DBGACK pin on the connected MPU?
- What is the adaptive clock? How RTCK signal is used?
- Restrictions for when debugging SMP processor by using the project file created by AMP configuration
- What should I do with pins on the board when ETM trace signal is not connected to ETM38 pin connector?
- Cores and peripheral devices are connected by daisy chain. How to set it?
Product Registration / License
- Which MAC address should I register when registering the user ID?
- How to register the user ID and How to get the license
- What should I do if I want to change the MAC address?
- How is adviceXross/adviceLUNA II/adviceLUNA/TRQerS series products licensed?
- MPU license error: Specified MPU license was not found.
- Specified MPU type is not supported.
Installation / Settings
- What should I select for ”Multicore debug” which is shown when creating a new project?
- Notes for versions of debugger
- An error occurs when installing the install kit.
- This installation is forbidden by system policy. Contact your system administrator.
- How to check the version upgrade?
- Make sure to install MPU system when using advice series products.
Function / How to use
- Breakpoint list which you have set is not shown correctly.
- What is the meaning of ”/” shown next to the line number?
- Unexpected break occurs while executing the program.
- The instruction loaded by ldr instruction is different from the expectation value if you set the software break.
- Step is not performed properly in assembler level. It is stuck at that instruction.
- How to specify address (numerical value)? How to specify the address range?
Connection to Target systems
- Break does not occur at reset vector address.
- How to set the reset vector address?
- What is the reset vector break?
- What is the difference between ”Reset and Connect and ”Connect” ?
- It executes the boot program of target even though the PC value is at the reset vector when executing the reset command.
- Debugger is not Attached to Target System. Please Attach a Debugger to the Target System by reset or attach exec
Trouble Shootings
- ICE Error No.ffc: Flash Memory Type is not correct.
- Some lines become void when displaying a source code which contains Japanese and Korean in C mode.
- Contact to customer support center
- ICE Error No.FC6: Data cannot be set up when address range is specified.
- USB Device not found
- ICE Error No.c01: Register Data Overflow
Usage Examples / Tips
- I want to see the contents of disassemble display in Thumb instruction display.
- Can I specify the external file by relative path?
- Automatic registration of path conversion information
- Can I execute the command file by synchronizing with RESET?
- Can I rewrite the memory by ASCII character?
- How to check whether the flash memory is writable or not?