[Supported model]
adviceLUNA, adviceLUNA2
[Scope of application]
ARM
[Error message]
ICE Error No.F1F: No external output resources of ETM available.
Check ETM resources status with the Config. tab of the ETM Control dialog box.
[Cause]
This error is output when the MPU you are using used the external output function exceeding the limit.
[Workaround]
Choose [MPU] - [ETM Control] from the menu bar of the microVIEW-PLUS.
Check the number listed for External Output listed on the [Config.] tab.
Then, choose [MPU] - [Trace Enable/ETM Setup] from the menu bar of the microVIEW-PLUS.
Check the number of events set up on the [Ext. Output] tab.
Make sure that this number of events does not exceed the number listed for External Output on the [Config.] tab.