[Supported model]
adviceLUNA, adviceLUNA2
[Scope of application]
microVIEW-PLUS
[Error message]
ICE Error No.8C4: Set Software Break Verify Error.
[Cause]
This error message appears if the error occurs in the memory rewriting process when setting the software break point in the ROM or SDRAM area.
[Workaround]
When setting the break point at an address in the user system memory, it is absolutely necessary that the memory is write-enabled.
If the user system has only ROM or FROM, you must use the break point using the chip built-in debug resource.
(However, note that there are limitations on the number of settings.)
When using the SDRAM, make the setting so that the memory can be accessed before downloading or setting the break point.