[Scope of application]
adviceXross, adviceLUNA II, adviceLUNA
[Question]
Displays the Thumb code area in disassemble display, but it is displayed in Arm code. How to display it in Thumb instruction display?
[Workaround]
Normally, Thumb code area can be shown in Thumb instruction display (16-bit instruction display) by registering the debug information (symbol information) in debugger.
If there is no debug information, or it cannot be shown in Thumb instruction display even with the above settings, you can forcibly display it in Thumb instruction display by doing one of the followings.
- Select ＜toolbar＞ from Windows menu, and then select ArmBar.
- A button to switch to forced Thumb mode is shown on the toolbar. Select the button.
Right-clicking the mouse button on the blank area at upper right corner (such as right side of Help) to display menu. Select ArmBar. - A button to switch to forced Thumb mode is shown on the toolbar. Select the button.